Learning values
The Learning tab of the ECU page shows what the ECU has learned while driving, all in one read: the ignition advance multiplier (IAM), the knock corrections, the fuel trims, the stored A/F learning and the fine knock learning table. It is the same idea as RomRaider's Learning Table Values.
The Learning tab has not been tried on a car yet.
Reading the learned values
- Connect your adapter and choose the vehicle, so an ECU protocol is selected.
- Turn the ignition on. The engine may be running.
- Open the Learning tab on the ECU page and press Read learning.
The card's header shows the ROM ID the ECU answered with, the definition that was used and when it was read. Values the ECU did not give are listed under Not read.
What is shown
- IAM and the knock corrections (fine and coarse).
- The conditions when it was read, and the current fuel trims.
- The stored A/F learning for each airflow range.
- The fine learning knock correction (FLKC) table, by engine speed and load.
What it needs
- A RomRaider logger definition (Settings › Files › Logger definitions) that has the learning addresses for your ECU's ROM ID. Extra logger files, such as FastECU's extended parameters, are read too (see Datalogging).
- A ROM definition for your ECU, found by the ECU id. The airflow ranges and the FLKC table's engine speed and load ranges are read from the ECU using it.
Reset learning
Reset learning sends the SSM ECU reset, after asking you to confirm. IAM goes back to its starting value, the A/F and knock learning are cleared, and the trouble codes are cleared too. Do it with the engine off and the ignition on. The ECU learns again while you drive.
Read and write down the learned values and the trouble codes first, because they are gone after the reset.