MAP sensor scaling
When you fit a different manifold pressure (MAP) sensor, the ECU has to be told how to turn the sensor's voltage into pressure. The MAP Sensor Scaling Calculator works out the values for the ROM's Manifold Pressure Sensor scaling tables from two points of the sensor's datasheet. It also shows what the ECU will read with them.
Opening it
Choose Tools › MAP Sensor Scaling Calculator… in the menu bar. It opens over whatever page you are on and remembers what you typed until the app is closed. It only calculates: nothing is written to a ROM. Type the values into the tables yourself.
Using it
- Pick the ECU's form of the scaling: Hitachi, Denso 32-bit or Denso 16-bit. The line under the buttons shows the formula the ECU uses.
- Pick the pressure unit: kPa, bar or psi. Pressures are absolute, as on a sensor datasheet (not boost / gauge pressure). Switching the unit converts what is already typed.
- Enter two points of the sensor's line, e.g. 0.5 V and 4.5 V with their pressures. The further apart the two points are, the better.
- Read the results:
- Value: what to type into each table in the calibration editor, in the definition's units.
- In the ROM: the raw value stored in the ROM, for checking in the hex editor.
- A table of what the ECU reads against what the sensor means at a few voltages (0 V, your points, the middle and 5 V), with the error.
- Copy puts everything on the clipboard as text, for your notes.
The calculator opens on the stock Hitachi sensor line (1.67 kPa at 0 V, 118.2 kPa at 5 V), so the stock Hitachi values come out. That makes it easy to check against a stock ROM.
Hitachi
Hitachi ROMs have three tables: Manifold Pressure Sensor Scaling Multiplier, Divisor and Offset. The ECU does integer arithmetic with them, and the calculator does exactly the same. Change all three together.
- The calculator picks the largest divisor that still fits, which gives the finest steps. Any sensor with more range than about 24 kPa per volt needs a smaller divisor than the stock 2300.
- The offset cannot be negative. Many aftermarket sensors would read below 0 kPa at 0 V. The ECU cannot store that, so the calculator sets the offset to 0 and picks the slope with the smallest error across your two points. It tells you how large that error is.
- Hitachi ECUs read up to about 273 kPa absolute (about 1.7 bar of boost at sea level). Above that the reading stays at 273 kPa. The manifold pressure value sent to the logger stops at about 136 kPa, and tables that use it may too, so check their axes before running boost.
Denso 32-bit
A multiplier and an offset, stored as decimal numbers: pressure = multiplier × voltage + offset. The definition shows them in bar per volt and bar. Any sensor line can be entered exactly, including a negative offset.
Denso 16-bit
A multiplier and an offset that is subtracted: pressure = voltage × multiplier − offset. The ECU repeats the conversion in three places, A, B and C: change all three multipliers and all three offsets. Because the offset is subtracted, the line cannot be raised above 0 kPa at 0 V. For a sensor like that, the calculator sets the offset to 0 and fits the slope, as for Hitachi.
After changing the values
- Check the result on the car: with the engine off, the manifold pressure in the logger should match the atmospheric pressure.
- A different sensor range also changes what the MAP sensor's fault limits mean. Look at the Manifold Pressure Sensor category for limit tables.